Jan 12, 2013 I've done some extra research and uncovered this thread from the TekSavvy section detailing how to enable Telnet access: »Firmware + Sagemcom. Bridging Gigaset/Sagem 4300 modem. How do I set my Gigaset/Sagem 4300 into bridge mode? Open your browser and go to Click on Login on the menu.

Contents • • • • • • • Getting started • Plug the power connector into the Sagemcom 2864 and plug the other end into an AC wall jack. • Note: there is no 'power on/off' switch on the Sagemcom 2864. • Note: the Sagemcom 2864 takes a long time to boot up, as much as five full minutes • Note: shows what the Sagemcom 2864 lights tell you.

• Connect an Ethernet LAN cable to one of the ports and the other end to your computer • Note: Do not connect anything to the cable coax connection. It should never be connected to any coax cable. • Connect the modem to the wall phone jack • In your browser's address bar, enter the IP address for the modem interface page, or click here: • If the modem is fresh from the factory, use the default user name and password to gain access: • user: admin • password: admin If the modem was previously configured for someone else, the password would be the previous user's. If it is unknown then do a reset to factory default, using a paper-clip in the reset hole on the back. Hold until the power light turns off to reset. The user name and password will now be as above. Note: The Sagemcom 2864 doesn't act like other modems after a factory reset.

Buku Ekonomi Internasional Pdf Editor. While most modems erase the password, reset everything to factory defaults and thus will not connect, the Sagemcom 2864 does not erase the password, but it does reset everything else to factory defaults. If the modem is connected to the internet after a reset it will sign on and connect, but will only go to a single Bell website intended to allow Bell customers to sign up.

NCF members can disregard this and proceed to configure the modem to connect to NCF's internet service. Note: When connecting the Sagemcom 2864 for the first time and occasionally on subsequent connections, the LED near the '@' symbol will flash red indicating that a firmware update is in progress. If this occurs then leave the modem on until the LED is no longer flashing red. No configuration should be attempted until this is complete. Adobe Flash Cs2 Portable Free Download. A firmware update may result in the loss of user name and password in which case the modem will only connect to the one Bell sign-up website, as mentioned above. This is an indication that it needs to be reconfigured with this information.

'' SAGEM ROUTER FAST 3304/3464/3504 - telnet root password generator. Work based on: '' import sys def mash( a, b): if a >b: b, a = a, b aa = int(a, 16) bb = int(b, 16) if bb.